Operating Modes; Sound Active Mode - ADJ ELEMENT QA User Instructions

Element QA
LCD Display Lock:
The display will lock after 30 seconds. Press and hold the MODE but-
ton for at least 10 seconds to unlock the display.
Operating Power:
There are two ways to supply power to this unit; battery power or AC
power. Note: You need to activate the LOAD function regardless
of how you supply power.
• AC Power - To run the unit using AC power, plug the unit into a
power source, and activate the Load setting. When using AC power
make sure the Battery Switch is in the OFF position.
• Battery Power - To run the unit using Battery power, switch the
battery switch located on the bottom of the fixture into the "On" pos-
tion, and activate the Load setting.
Load Setting
You need to activate this function regardless of Battery power or
AC power. This function activates the LED PCB output.
1. To activate Load, press the MODE button until either "bXXX",
"bsXX", or "LoXX" is displayed. "XX" is the represents the current
setting of those menus.
2. Press the SET UP button so that "LoXX" is displayed. "XX"
represents either "oN" or "oF" (Off).
3. Press the UP or DOWN buttons so that "oN" is displayed.
Energy Saving Mode
This will decrease the LED's brightness gradually when the battery
life is less than 80%, this is will extend the battery life.
1. To activate energy saving mode, press the MODE button until
either "bXXX", "bsXX", or "LoXX" is displayed. "XX" is the repre-
sents the current setting of those menus.
2. Press the SET UP button so that "bS:XX" is displayed. "XX"
represents either "ON" or "OFF".
3. Press the UP or DOWN button so that "ON" is displayed. If "ON"
is displayed already then the fixture is already in energy saving
mode.
ADJ Products, LLC - www.adj.com - Element QA User Manual Page 24
Operating Instructions Element QA
LED Display On/Off:
To set the LED display light to turn off after 20 seconds, press the
MODE button until "dXX" is displayed. "XX" represents either ON or
OFF. Press the UP or DOWN buttons so that OFF is displayed. Now
the display light will turn off after 30s. Press any button to turn the
display on again.

Operating Modes:

The Element QA has five operating modes:
• RGBA Dimmer Mode - Choose one of the four colors to remain
static or adjust the intensity of each color to make your desired
color.
• Sound-Active mode - The unit will react to sound, chasing through
the built in programs. There are 16 sound active modes.
• Auto Run Mode - In Auto Run mode, you can choose 1 of 16
color change modes, 1 of 16 color fade modes, or a combo color
change & fade mode.
• Static Color Mode - There are 64 colors to choose from.
• DMX control mode - This function will allow you to control each
individual fixtures traits with a standard DMX 512 controller.

Sound Active Mode:

1. Plug the fixture in and press the MODE button until "SoXX" is dis-
played. "XX" represents the current sound active mode (1-16).
2. Use the UP or DOWN buttons to find your desired sound active
mode.
3. Press the SET UP button to enter sound sensitivity adjustment.
"SJ-X" will be displayed. Use the UP or DOWN buttons to adjust
the sensitivity. "SJ-1" is the lowest sensitivity, "SJ-8" is the high-
est. "SJ-0" turns the sound sensitivity off.
ADJ Products, LLC - www.adj.com - Element QA User Manual Page 25
Operating Instructions