Table of Contents
Advertisement
e)
Remove the four burner retaining screws as indicated in Fig. 13 below
Fig. 13
2 off L/H Burner
Retaining Screws
f)
Slide the burner assembly to the left, off the injector and remove the
from the firebox.
4.3
REMOVING THE CONTROL TAP FROM THE FIRE
a)
Disconnect the appliance from the gas supply.
b)
Remove the burner assembly as shown in section 4.2.
c)
Disconnect the pilot pipe, inlet pipe,valve to injector pipe and push fit
thermocouple as shown below in Fig. 14
d)
Re-assemble in reverse order and carry out a gas tightness test.
Fig. 14
Push Fit
Thermocouple
18
2 off R/H Burner
Retaining Screws
Pilot Pipe
Inlet Pipe
Valve to Injector Pipe
Hide quick links:
Advertisement
Table of Contents
