Replace Carbon Brushes - Invacare Bora Service Manual

•
Remove the clutch (2) from the motor (1)
using the screwdriver
•
Place a new clutch on the motor. Observe
the position of the groove (3) on the motor.
•
The motor is reassembled in reverse order
to disassembly.
•
Insert the motor carefully into the
transmission to avoid damage. Observe the
position of the groove (1) in the
transmission.
• The cable must be routed so that it does not
rub or get trapped.
•
Insert the motor plug into the electronics
module.
•
Secure the motor cable with cable ties.
7.2.4

Replace carbon brushes

NOTE:
The carbon brushes are located under plastic caps outside each motor. This makes them easily
accessible so that they can be replaced without removing the motor.
Always replace the carbon brushes on both motors.
•
Carefully remove the plastic cap (1) on the
motor with the screwdriver.