Invacare Bora Service Manual page 34

CAUTION: fitting the incorrect strip fuse causes a fire hazard!
• Only fix the strip fuses in the sequence shown in the image on the right!
• Tighten the nuts with 3.3 to 3.5 Nm!
Requirements:
• Phillips screwdriver
• Strip fuse
NOTE:
A spare fuse is located behind the Invacare logo on the rear battery.
NOTE:
If the fuseholder is damaged, you can replace this complete with the battery cables.
• Remove both battery cases as described in
Chapter 7.5.1.
• Remove the covers on both battery cases as
described in Chapter 7.5.2.
• The fuseholder (1) is located on top of the
batteries.
• Open the fuseholder cover.
• If the strip fuse has blown, you must first
ascertain and rectify the cause of the fault.
• The main fuse may only be replaced once
the fault has been rectified.
1. Strip fuse
2. Spade terminal
3. DIN 6923 nut