7.12
Checking an adjusting motor
Tools/parts required:
• Multimeter
•
Remove legrests.
•
Release seat (1) and tilt forwards.
•
Remove the adjusting motor plug from the
electronics module or ACT (see Chapter 4.2.
•
Check the electrical resistance at the
adjusting motor plug (1).
The plug may have a different shape to that
shown in the picture.
•
If the resistance is close to infinity, the motor
is probably burnt out.
•
If the resistance is below 1 Ω, the motor has
a short-circuit.
•
The motor must be replaced in both cases.
7.13
Replacing the seat tilting
Requirements:
• flat screwdriver, blade width approx. 6 mm
• oblique pliers
• small hammer
• cable binder