Adjusting The Seat Depth To The User's Seating Position; Standard Seat - Invacare Bora Service Manual

8

Adjusting the seat depth to the user's seating position

In order to adapt the mobility device optimally to the requirements of the user, we recommend that
you ask your authorised Invacare® the dealer toadjust the seat depth individually.
Adapting the seat to the user's seating position depends on which seat has been fitted, and should
be carried out in the following sequence.
1. Adjust the seat depth to the seat frame.
2. Adjust the seat area.
3. Check to ensure that the steering wheels can rotate freely
4. Repeat steps 1 to 3 if necessary
A seat frame with a range of threaded holes is located under the seat. Depending on which seat
which has been fitted, it can be adjusted to various locations on the seat frame which defines the
seat depth.
In addition, you can move the seating area and fix it in different positions.
CAUTION! Injury hazard
• The steering wheels must rotate freely and may not contact any fixed mobility device
components.
Always check the seat depth settings for both forward and reverse movement.
What needs to be observed when adjusting the seat depth?
If the seat depth is too short, the force required when the user stands up is too high. If the seat
depth is set too long, the user may "slump down" while getting up.
Requirements:
• Allen key 5 mm
8.1

Standard seat

The pictures show the standard seat from above
and below.