Repair Work; General Warning Information About Fitting Work; Replacing Drive Components - Invacare Bora Service Manual

7

Repair work

7.1

General warning information about fitting work

CAUTION: Danger of damage to vehicle! Collisions can be caused if the adjusting
washers are removed during fitting work to the drive wheels!
• Adjusting washers are often fitted between the drive shaft and the wheel hub to even out
tolerances. If these adjusting washers are removed and not replaced again, collisions can be
caused! Always replace the adjusting washers exactly as they were before you started
dismantling!
7.2

Replacing drive components

CAUTION! Tipping and crushing hazard!
• Remove the seat and place the mobility device upside down so that the wheels are facing
upwards! This guarantees mobility device stability during repair work!
• You should seek help from a second person!
• Please see the following work steps for further important information.
CAUTION: Fire and burns hazard if battery terminal is bypassed!
• When replacing batteries, the battery terminals may not come into contact with mechanical
mobility device components and be short-circuited!
• Always replace battery terminal caps after replacing the batteries!
Requirements:
• small flat screwdriver
• Torx TX40 spanner
• Allen key 5 mm
• oblique pliers
• Cable binder
NOTE:
When disassembling, take care of small parts such as screws and washers. Put all small parts
down so that they can be reassembled in the right sequence.
• Remove legrests.
•
Release seat (1) and tilt forwards.
• Disconnect the remote bus cable from the
electronics module or ACT.
•
Lift the seat out of the front anchorage and
remove it. When doing so, get the help of a
second person because the seat is heavy.