Installing The Y Connector (Optional) - Piazzetta P960 Instructions For Installation, Use And Maintenance Manual

5.4 INSTALLING ThE y CONNECTOR (OPTIONAL)

• The ducting of heat to adjoining rooms is at the user's discretion
according to requirements.
• The Y connector, designed to double hot air delivery, may be fitted
onto one or both fans at the time the stove is installed.
• If just one Y connector is used, it is more convenient to fit it onto the
right fan [1] (as seen from the rear). If two Y connectors are to be
used, first work on the left fan [2] and then on the right [1] (as seen
from the rear Fig. 46).
To install, proceed as follows:
- remove the side ceramic panels and the rear panel of the stove;
- uncoil the hose from the appropriate fan outlet by loosening the clip
that holds it in place (Fig. 47);
- cut off approx. 2" / (5 cm) of hose (Fig. 48);
- fit the hose to the Y connector using the clip provided in the kit (Fig.
49);
- fit the Y connector to the fan outlet using the screws provided in the
kit (Fig. 50);
- fit the second hose to the Y connector using the clip provided in the
kit (Fig. 51);
- repeat steps 2 ÷ 6 for the other fan if two Y connectors are being
used;
- remove the knockout from the rear panel and insert the ducting
through the hole that has been created (Fig. 52);
- refit the rear panel and the side ceramic panels;
- move the stove closer to the wall (Fig. 53) and, using the clips provided
in the kit, fix the two hoses to the walled ducting fittings (Fig. 54);
- put the stove in its final location, complying with the minimum
safety distances (see par. 1.6).
24
Fig. 46
Fig. 47
Fig. 49
Fig. 51
Fig. 53
H07028100/DT2000970 – 01
FAN 2
Fig. 48
DT2031048-00
Fig. 50
DT2030175-00
Fig. 52
DT2030178-00
Fig. 54
DT2030180-00
DT2010148-04
FAN 1
DT2030229-01
DT2030230-00
DT2030232-00
DT2030233-00
DT2030181-00