Multicomfort; Energy Saving - Piazzetta P960 Instructions For Installation, Use And Maintenance Manual

6.12 MULTICOMFORT

The pellet stove is fitted with the Multicomfort function. This works in conjunction with the Multifuoco ventilation system to improve heat distribution.
It allows the room temperature to be read from the stove or from the remote control, so that the Multifuoco settings can be varied according to the
requirements of the rooms to be heated.
If the airflow from your stove has been ducted to other rooms you may read the temperature in the room where the stove is installed or in the room
where the remote control is situated.
Example: your stove is installed in a small room and you are ducting the heat only from the rear of the stove (see solution 1 under the paragraph
"MULTIFUOCO SYSTEM"). You can position the remote control in the room to where the hot air has been ducted and set the required temperature
from this room. To carry out the necessary settings see the MULTICOMFORT menu.
The pellet stove is fitted with another function which allows the installation to operate with separate fans. This function allows differentiated hot air
distribution from the two fans thereby fully exploiting the functionality of the Multicomfort system.
Example: your stove is installed in one room and hot air is ducted from one fan to an adjoining room (see solution 2 under the paragraph "MULTIFUOCO
SYSTEM"). You can position the remote control in the room to where the hot air has been ducted and set the required temperature from this room.
You can also set the fans separately, increasing or decreasing the Multifuoco airflow for the same room.
To carry out the necessary settings see the MULTICOMFORT - FANS MODE menu.
For airfl ow controls see the paragraph entitled "NORMAL OPERATION".
This function is used to choose the sensor for reading the room temperature: from the stove or from the remote control. To make the
most of the Multifuoco fan functions read the paragraphs MULTIFUOCO SYSTEM and MULTICOMFORT OPERATION.
Function
Select the
Press the MENU key, then using the SELECT MENU key select the
MULTICOMFORT
MULTICOMFORT menu. Confirm by pressing the SET key
menu
Press the SELECT MENU key and select "SELECT RRC" to read the room
Select the REMOTE temperature from the remote control or "SELECT STOVE" to read the
CONTROL SENSOR room temperature from the stove. Confirm by pressing the SET key. After
(SELECT RRC) or confirmation the readout function enabled (FUNCTION ENGAGED) will
STOVE (SELCT STOVE) appear on the display and the remote control will automatically return to
the initial display.

6.13 ENERGy SAvING

When the ENERGY SAVING mode is enabled, automatic startup/ignition and shutdown of the stove is activated at temperature values set by the user
through the STOP and START functions.
The temperaturThe operating principle is as follows:
when the room temperature measured by the room sensor, the remote control or the external thermostat reaches the temperature value programmed
44
MULTICOMFORT
Action
H07028100/DT2000970 – 01
DT2010256-00
Display
M U L T I
M U L T I M U L T I
C O M F O R T
C O M F O R T C O M F O R T
1
1 1
S E L E C T
S E L E C T S E L E C T
R R C
R R C R R C
1
1 1
S E L E C T
S E L E C T S E L E C T
S T O V E
S T O V E S T O V E
1
1 1
DT2040070-04
DT2012431-00