Swashplate/Washout Installation - JR Vibe Fifty Assembly Instructions Manual

4-1

SWASHPLATE/WASHOUT INSTALLATION

Setscrew, 3x3mm (3pcs)
Socket Head Bolt, 3x14mm (2pcs)
Flat Head Screw, 2x10mm (6pcs)
Steel Joint Ball (6pcs)
If there is play between the upper and lower Swashplate,
tighten set screw 3 x 3 mm to lower the swashplate
little by little. Do not overtighten as binding and damage
to the bearing can occur.
Hold Upper Plate
and check play.
120/140 Swashplate Assembly
Long Control Ball,
28.25mm (2pcs)
140 CCPM
Control Ball, 9mm (2pcs)
It is a good idea to size the
ball links with the JR Ball
Link Sizing tool prior to
attachment.
Joint Ball Spacer, 2.75mm (4pcs)
Washer, 3x4.5x0.4mm (2pcs)
Control Ball, 9mm (3pcs)
Long Control Ball, 28.25mm (2pcs)
Washout Base
120 CCPM
base faces downward toward the
Washer, 3x4.5x0.4mm (2pcs)
This Position
Setscrew,
3x3mm (3pcs)
25
Install the long control balls for
140 CCPM or the short control
balls for 120 CCPM depending
on the type you will use.
Install the washout assembly
on the main rotor shaft so the
longer portion of the washout
swashplate.
Washout Arm
Assembly (2pcs)
Socket Head Bolt,
3x14mm (2pcs)
Control Ball, 9mm
Flat Head Screw,
2x10mm (6pcs)
Steel Joint Ball (6pcs)
Joint Ball Spacer,
2.75mm (4pcs)