Swashplate Adjustment; Swashplate/Washout Assembly Installation - JR ERGO Assembly Instructions Manual

4-5
........3 pcs
4x4mm Set Screws

Swashplate Adjustment

The 120° CCPM swashplate is adjustable via the
3 – 4X4mm set screws. If excessive play is found in
the test above, gently tighten each of the 3 – 4mm set
screws the same amount and re-test. The swashplate
should move freely, but without notable play.
Caution:
If the 3 – 4mm set screws are over tightened, damage
to the swashplate bearings can occur.
4-6
Option: For smooth operation,
pre-size the ball links with the
JR ball link sizing tool prior to
attachment.
*WASHOUT ASSEMBLY INSTALLATION
When installing the washout assembly be sure the long flange of the
mixing base is positioned downward (toward the swashplate) with the
short portion facing upward.
Washout Assembly
UP
Long portion of mixing base flange
must face downward.
SWASHPLATE ADJUSTMENT
While holding the inside ball race, pivot the swashplate &
check for excessive play. Adjust as necessary.

SWASHPLATE/WASHOUT ASSEMBLY INSTALLATION

Washout Assembly
120° CCPM Swashplate Assembly
Washout unit to swashplate connection.
Connect the two washout links to the two
long upper swashplate balls as shown
Swashplate Adjustment Test
22
CCPM Swashplate Assembly
Upper Swashplate Ring
4x4mm Swashplate Adjusting Screws
(Caution: Do not overtighten!)
Complete Assembly
Lower Swashplate Ring