Draytek Vigor 2925 Series User Manual page 234

Dest IP End
Dest Port Start
Dest Port End
Move UP/Move Down
Wizard Mode
Advance Mode
To use Wizard Mode, simple do the following steps:
1. Click the Wizard Mode radio button.
2. Click any Index number link (e.g., 2 in this case). The setting page will appear as follows:
Available settings are explained as follows:
Item
Source IP
Destination IP
3. Click Next to get the following page.
Vigor2925 Series User's Guide
Display the IP address for the end of the destination IP.
Display the IP address for the start of the destination port.
Display the IP address for the end of the destination port.
Use Up or Down link to move the order of the policy.
Allow to configure frequently used settings of route policy
via three setting pages
Allow to configure detailed settings of route policy.
Description
Any – Any IP can be treated as the source IP.
Src IP Start - Type the source IP start for the specified
WAN interface.
Src IP End - Type the source IP end for the specified
WAN interface. If this field is blank, it means that all the
source IPs inside the LAN will be passed through the WAN
interface.
Any – Any IP can be treated as the destination IP.
Dest IP Start- Type the destination IP start for the
specified WAN interface.
Dest IP End - Type the destination IP end for the specified
WAN interface. If this field is blank, it means that all the
destination IPs will be passed through the WAN interface.
222