Draytek Vigor 2925 Series User Manual page 207

D e t a i l s P a g e f o r L
D e t a i l s P a g e f o r L
There are two configuration pages for LAN1, Ethernet TCP/IP and DHCP Setup (based on
IPv4) and IPv6 Setup. Click the tab for each type and refer to the following explanations for
detailed information.
Available settings are explained as follows:
Item
Network Configuration
DHCP Server
Configuration
A N 1 – E t h e r n e t T C
A N 1 – E t h e r n e t T C
Description
For NAT Usage,
IP Address - Type in private IP address for connecting to a
local private network (Default: 192.168.1.1).
Subnet Mask - Type in an address code that determines the
size of the network. (Default: 255.255.255.0/ 24)
RIP Protocol Control,
Disable - deactivate the RIP protocol. It will lead to a
stoppage of the exchange of routing information between
routers. (Default)
Enable – activate the RIP protocol.
DHCP stands for Dynamic Host Configuration Protocol.
The router by factory default acts a DHCP server for your
network so it automatically dispatch related IP settings to
any local user configured as a DHCP client. It is highly
recommended that you leave the router enabled as a DHCP
server if you do not have a DHCP server for your network.
If you want to use another DHCP server in the network
other than the Vigor Router's, you can let Relay Agent help
you to redirect the DHCP request to the specified location.
Enable Server - Let the router assign IP address to every
host in the LAN.
Disable Server – Let you manually assign IP address to
every host in the LAN.
Enable Relay Agent –Specify which subnet that DHCP
server is located the relay agent should redirect the DHCP
request to.
195
P / I P a n d D H C P S e
P / I P a n d D H C P S e
t u p
t u p
Vigor2925 Series User's Guide