Installation Tips - Vivax ACP-12CT35GECI Service Manual

7.3 Installation Tips

1.Removing and installing front pane
Removal method
1)Slide until the 2 stoppers click into place
2)Open the front panel forward and undo the string
3)Remove the front panel
Installation method
1)Attach the front grille and front panel after pulling the
string around them.
2)Close the front panel and slide until the stoppers click
outside.
2.Removing and installing front grille
Removal method
1).Open the front panel.
2)Remove the 4 screws and remove the front grille while
pulling it forward(3 tabs).
Installation method
1)Secure the front grille with the 4 installation screws
(3 tabs)
2)Return the front panel to the original position.
3.How to set the different addresses
When two indoor units are installed in one room, the two wireless remote controllers can be set for different addresses.
1)Remove the front grille.
2)Live the sensor securing plate and remove the front metal plate cover.
3)Remove the electric box(1 screw).
4)Remove the thermistor.
5)Remove the side metal plate cover(7 tabs).
6)Cut the address jumper(JA )on the printed circuit board.
3 Remove 1 screw
26
Front panel
4)Thermistor
3 tabs
Remove 4 screws
Open the front panel
ADRESS
JA
JA
EXIST 1
CUT 2
2)Sensor securing plate
2)Front metal plate cover
5)Side metal plate cover
Installation Manual
Casing
Front
grille
Remove
front grille