Vivax ACP-12CT35GECI Service Manual page 25

Function and Control
TURBO:
14
Press this button to activate / deactivate the Turbo function which enables the unit to
reach the preset temperature in the shortest time. In COOL mode, the unit will blow strong
cooling air at super high fan speed. In HEAT mode, the unit will blow strong heating air
at super high fan speed.
15
LIGHT:
Press LIGHT button to turn on the display's light and press this button again to turn off
the display 's light. If the light is turned on ,
disappears.
X-FAN:
16
Pressing X-FAN button in COOL or DRY mode,the icon
fan will continue operation for 10 minutes in order to dry the indoor unit even though you
have turned off the unit.
After energization, X-FAN OFF is defaulted. X-FAN is not available in AUTO,FAN or
HEAT mode.
Combination of "+"
17
Press "+ " and "-" buttons simultaneously to lock or unlock the keypad. If the remote
controller is locked,
three times.
Combination of "MODE " and "-" buttons :
18
At unit OFF, press
19 Combination of " TEMP " and "CLOCK" buttons : About Energy-saving Function
Press "TEMP" and "CLOCK" simultaneously in COOL mode to start energy-saving function.
Nixie tube on the remote controller displays "SE". Repeat the operation to quit the function.
20 Combination of " TEMP " and "CLOCK" buttons : About 8
Press "TEMP" and "CLOCK" simultaneously in HEAT mode to start
Nixie tube on the remote controller displays "
(46 if Fahrenheit is adopted). Repeat the operation to quit the function.
21
About Back-lighting Function
The unit lights for 4s when energizing for the first time, and 3s for later press.
Replacement of Batteries
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
●
When replacing the batteries, do not use old or different types of batteries,
otherwise, it may cause malfunction.
● If the remote controller will not be used for a long time, please
remove batteries to prevent batteries from leaking.
●
The operation should be performed in its receiving range.
●
It should be kept 1m away from the TV set or stereo sound sets.
●
If the remote controller does not operate normally, please take the
batteries out and reinsert them after 30 seconds.If it still can't operate properly,
replace the batteries.
and "-" buttons: About lock
is displayed. In this case, pressing any button,
About switch between Fahrenheit and centigrade
" "
" - "
MODE and buttons simultaneously to switch between
is displayed. If the light is turned off,
is displayed and the indoor
Heating Function
8 Heating Function
" and a selected temperature of " 8 "
Sketch map for
replacing batteries
blinks
and .
.
21