Advertisement
5. INSTALLATION METHOD
Wire controler
When a wire controller is needed, a small 5-way terminal should be added,fix an infrared emitter with gumwater
near the receiver on the switch board. Connect its anode and cathode to A and B,and +5V, GND, RUN to C, D, E
on the switch board.
6. NAME AND OPERATION OF THE BUTTON ON THE WIRE CONTROLLER
MODE BUTTON
TIMERON BUTTON
FOLLOWME BUTTON
TIMER OFF BUTTON
ELECTRICAL
HEATERBUTTON
RESET BUTTON
NOTE
All the pictures in this manual are for explanation purpose only. There may be slightly different from the wire
controller you purchased(depend on model). The actual shape shall prevail.
5-way terminal
5-Core Shield Cable
4
Emitter tube
Indoor switch board
Indoor Unit
ON / OFF BUTTON
ADJUST BUTTON ▲
ADJUST BUTTON ▼
SWING BUTTON
ECONOMY BUTTON
FAN SPEED BUTTON
LOCK BUTTON
Advertisement
Chapters
