Button Tags - 2N Helios IP Force Installation Manual

2.5 Button Tags

This subsection describes work with Button Tags in
Tag Printing
1. Every
can be laser-printed. Cut the printed foil and insert the tags in the name plates.
2. Every name plate includes a piece of foil, which can be written over manually,
using a waterproof permanent marker, if necessary.
Note
Tip
Tag Inserting/Replacing Instructions
®
2N Helios IP Force provides an intuitive, easy access to the name
plates. The tags are easy to insert and replace even without a
manual. You need not remove the front panel and thus are not
exposed to the risk of loss of components while replacing the tags.
1. Loosen the name plate screw using the wrench enclosed, for
example. You can open the name plate window like a door
without losing the tightened screw.
2. Remove the used or blank name tag and insert a new tag.
3. Close the name plate window and tighten the screw
appropriately.
4. Check the click effect of the buttons: if the button fails to click
properly when pressed (when moved by approx. 0.5 mm), the
tag is too thick or thin. Make sure that the button clicks when
you press it on both ends.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2N Helios IP Force
Always use waterproof foil (enclosed or other) for the tags. Never use
paper or ink jet printing to avoid damage due to water leakage!
A template for printing nametags can be downloaded from
®
2N Helios IP Force
delivery includes a sheet of translucent foil, which
.
www.2n.cz .
47