Ch Set; Out Swap - GRAUPNER mz-24 HoTT Operating Instructions Manual

12. CH Set

It is used to set the channel of a transmitter. The basic setup of the transmitter's channel is set
differently depending on 3 different types ("model type", "wing type", and "swash type") and mz-12
offers AUX channel to set the switch, volume, and side lever for your purpose. Touch "CH set" icon
on base menu page to call to "CH set" setup page. In "Ch Set" setup page, the basic functions of
the transmitter which is connected individually to every channel are displayed. AUX channels are
displayed as NONE when they are not connected to a servo. To connect AUX channel to a servo,
touch "NONE" icon to call the "select" message popup and move the switch, volume or side lever
with your choice then the selected switch, volume or side lever is set to AUX channel and the
connected servo is controlled. Touch "SERVO" icon on the right to call the "SERVO VIEW" page,
you may check the operating status of servo connected AUX channel in this page. Touch "BACK"
icon to return the previous page.
Touch
26

13. Out Swap

Touch
This function is used to edit the channel connection between transmitter and receiver. (It is
similar to TX OUT SET function in TX ctl, but Out Swap function is operated without trans-
mitting the setup data to a receiver unlike TX OUT SER function. Even if receiver channels
are more than transmitter channels, you are able to set receiver channel in "TX OUT SET"
function, but "Out Swap" function allows you to edit only twelve channels connected to the
transmitter.)
In base menu page, touch "Out.Swap" icon to call "Out. Swap" setup page. The channel order
of transmitter is set as the same as the order of receiver. Touch the channel number to activate
in blue and decide the desired channel number with "INC" and "DEC" button. Every channel is
set in the same way. After setup, touch "BACK" icon to return to the base menu page.
Touch
Touch
Touch
Touch
Touch
Touch