Table of Contents
Advertisement
Installation and Start Up
The following items are included with your 8700 Series console: Quick Start Guide, User Guide CD,
110V Mains AC Cable, Warranty card.
Warnings !
!
Do not expose unit to rain or moisture, or damage may occur.
!
There are no user serviceable parts inside. Do not attempt any repairs yourself, as doing so will void
the warranty. Please contact Leviton Technical Support if the unit is not functioning properly.
!
If the unit has been stored in a cold environment (below 40ºF), do not turn the power on until it
warms up or else damage may occur. Avoid situations that could cause condensation to occur inside
the unit.
!
Make sure that the mains power outlet matches the required voltage for your unit.
!
Do not operate this unit if the power cord is frayed or broken.
!
Do not remove the ground prong from the power cord. The ground prong is used to reduce the risk
of electrical shock and fire in case of an internal short.
!
Do not operate this unit if it becomes damaged in any way.
!
Never operate this unit with its cover removed.
Power On
WARNING! If there is any visible damage to the packaging or console, do not attempt to switch on
the console. Please contact your Leviton Dealer immediately.
1. Plug Mains cable into a 110V AC outlet.
2. Connect monitors to the VGA connectors on rear panel. Touring models include a monitor already
connected to VGA-1.
3. Plug DMX control cables into the DMX OUT connectors on rear panel.
4. Turn Power Switch (located on rear panel) On.
5. After a short boot-up process, the console is ready to operate.
6. Make sure the Grand Master (GM) is at full and the [BLKOUT] key LED is off.
Rev. A
Page 3
Advertisement
Table of Contents
