Table of Contents
Advertisement
Crossfader Playback Display Area
1.
3.
The Crossfader Playback Display Area in the Base Screen contains the following information:
1. Crossfader Status Line: SX level, Fade rate, Crossfader configuration.
2. Cue Times (Fade-in, Fade-out, Auto, Wait-in, Wait-out), Tm (Timing Mode), Jump,
Lp (Loop), Text (Cue Name).
3. Playback progress of X1/X2:
Code
T↑
X1/X2
Light Cyan
Assigning Cues to the Crossfader
The following procedure shows how to assign Cues 1 thru 10 to the Crossfader.
Procedure:
1. Record Cues.
2. Press [CUE] [1] [THRU] [10].
3. Press [ASSIGN].
If the first cue number is omitted when using [THRU], the cue list begins with the first recorded
cue. If the last cue number is omitted, the list ends with the last recorded cue. To assign all
recorded cues, press [CUE] [THRU] [ASSIGN]. To add a new cue to a currently assigned list,
press [CUE] [ASSIGN].
Deleting Cues from the Crossfader
To delete cues assigned to the Crossfader, press [DELETE] [ASSIGN].
Manual Crossfader Playback
When both X1 and X2 are at the top extreme of fader travel, X1 is the active fader at 100% while X2 is
at 0%. The crossfade ends when both faders reach the other extreme (X1 at 0%, X2 at 100%). When
the crossfade ends, the cue in X2 moves to X1 while the next cue in the cue list moves to X2. An LED
above each fader indicates the direction in which to end the current crossfade.
Rev. A
T↓
Fade-in
Fade-out
Cyan
2.
T
T↑
Auto
Wait-in
Dark Blue
Dark Gray
Notes:
Cue 1 is loaded as next Cue to execute.
T↓
Wait-out
Gray
Page 33
Advertisement
Table of Contents
