Table of Contents
Advertisement
Fixture Control Parameters (Lamp On, Lamp Off, Reset)
Before programming, the Fixture's lamp must be turned on. Fixture Control Parameters such as Lamp
On, Lamp Off and Reset are executed as follows:
Lamp On: Select Fixtures then Press [PARAM] [91].
Lamp Off: Select Fixtures then Press [PARAM] [92].
Fixture Reset: Select Fixtures then Press [PARAM] [93].
The above commands can be used concurrently with different Fixture types.
If the Fixture has additional Control Parameters, select the Fixture then Press [PARAM] [0] [@].
Next, select the additional Control Parameter number [#] from the Options Window. Note that this
command is specific to each Fixture type.
Editing Fixture Intensity Levels
Once the Fixtures are selected and lamped on, you can use the Intensity Wheel or Keypad to set
levels. For example, the following commands are used to assign a level to Fixture 1 using the Keypad:
[FIXTURE] [1] [@] [05]: Sets level at 5%.
[FIXTURE] [1] [@] [@]: Sets level at 100% (FF).
[FIXTURE] [1] [CALL]: Sets level at 100% (FF) with a 2 second fade in time.
[FIXTURE] [1] [
[FIXTURE] [1] [
[FIXTURE] [1] [@] [.]: Sets level at last keyed-in level.
Editing Pan and Tilt Parameters with the Trackball
Selected Fixture Pan and Tilt parameters are edited via the Trackball. The Encoder Wheels can be used
Editing Parameters with Encoder Wheels
also, see
The Trackball has three modes that are selected with the [TB] key:
Normal: Trackball controls Pan and Tilt parameters simultaneously. [TB] LED is off.
None: Trackball is inactive. [TB] LED is on.
Orthogonal: Trackball controls Pan and Tilt parameters independently. [TB] LED blinks.
The Trackball's and X / Y Encoder Wheels' sensitivity can be adjusted with the [FINE] key:
Normal: Regular sensitivity. [FINE] LED is off.
High: Fine sensitivity. [FINE] LED is on.
Low: Coarse sensitivity. [FINE] LED blinks.
The Trackball can also be used as a mouse. Press [MOUSE] to activate. Press [TB] to return to
Trackball mode.
Editing Parameters with the Encoder Wheels
Parameter, such as Gobo selection and Gobo rotation, a # symbol will appear next to the Parameter
name. Press the [
Rev. A
]: Increases level by 5%.
]: Decreases level by 5%.
Fixture Parameters and their respective values are displayed in
the Auxiliary Screen and the LCD display located above the
three Encoder Wheels. To view additional Parameters, press
the [][ ] keys.
Use the Encoder Wheels to step through and edit Parameter
values. The current Parameter being edited is indicated with an
* symbol next to its name.
If there are different modes defined within the same
] [
] keys to move to the next mode.
below.
Page 21
Advertisement
Table of Contents
