Ampro LittleBoard800 Reference Manual page 34

Chapter 3
Pin # Signal
97 (D7) AD12
98 (D8) +3.3V
99 (D9) PAR
100 (D10) NC
101 (D11) GND
102 (D12) DEVSEL* S/T/S
103 (D13) +3.3V
104 (D14) C/BE2*
105 (D15) GND
106 (D16) AD19
107 (D17) +3.3V
108 (D18) IDSEL2
109 (D19) IDSEL3
110 (D20) GND
111 (D21) AD27
112 (D22) AD31
113 (D23) VI/O
114 (D24) GNT0*
115 (D25) GND
116 (D26) CLK1
117 (D27) GND
118 (D28) RST*
119 (D29) INTC*
120 (D30) GND
Notes: The shaded area denotes power or ground. The signals marked with * = Negative true logic.
The Input/Output signals in this table refer to the input/output signals listed in the PCI Local Bus
Manual, Revision 2.2, Chapter 2, paragraph 2.1, Signal definitions. The following terms or
acronyms are used in this table:
•
In – Input is standard input only signal
•
Out – Totem Pole output is a standard active driver
•
T/S – Tri-State is a bi-directional input output pin
•
S/T/S – Sustained Tri-State is an active low tri-state signal driven by one and only one
agent at a time
•
O/D – Open Drain allows multiple devices to share as a wire-OR.
28
Input/ Description
Output
T/S Address/Data Bus Line 12 – Refer to pin-A3 for more information.
+3.3 volts ±5% power supply input
T/S Bus Parity bit – This signal is the even parity bit on AD[31:0] and
C/BE[3:0]*
Not connected (Snoop Done)
Ground
Device Select – This signal is driven by the target device when its
address is decoded.
+3.3 volts ±5% power supply input
Command/Byte Enable 2 – Refer to pin-A4 for more information.
Ground
T/S Address/Data Bus Line 19 – Refer to pin-A3 for more information.
+3.3 volts ±5% power supply input
Initialization Device Select 2 – Refer to pin-A18 for more info.
Initialization Device Select 3 – Refer to pin-A18 for more info.
Ground
T/S Address/Data Bus Line 27 – Refer to pin-A3 for more information.
T/S Address/Data Bus Line 31 – Refer to pin-A3 for more information.
+5 volts ±5% (Reference voltage only)
T/S Grant 0 – Refer to pin-A25 for more information.
Ground
In Clock 1 – Refer to pin-A27 for more information.
Ground
PCI bus reset – This signal is an output signal to reset the entire PCI
In
Bus. This signal will be asserted during system reset.
O/D Interrupt C – This signal is used to request interrupts only for multi-
function devices.
Ground
Reference Manual
Hardware
LittleBoard 800