Pilot+ Output Stage - Permobil Chairman 2k Service Manual

Pilot+ controller
Removal
1. Run the seat up to its highest position.
See page 7 for instructions to raise the seat
manually.
2. Switch off the main power switch on the
control panel.
3. Set the main fuse to the "OFF" position,
page 30, fig. 66.
4. Detach the seat lift and chassis covers,
see page 8.
5. Lift the Pilot+ controller out of its holder,
see fig. 50.
6. Loosen the electrical connections to the Pilot+
controller, take note of their placement for
purposes of later remounting, see fig. 51.
Fitting
Fitting is performed in reverse order.
NB! Make sure that no cables are to be found in
the area under the seat lift by the seat lift's drive
belt, see fig. 52.
Warning! The Pilot+ controller must be pro-
grammed before the wheelchair is taken into use.
Otherwise the wheelchair may be very difficult to
maneuver, with a high risk of accidents.
Warning! Test the way the wheelchair runs in a
large open space. If the Pilot+ controller is
incorrectly installed or incorrectly programmed,
the chair may move rapidly in the wrong direction.
Check carefully that it runs correctly in response to
the controls.
Fig. 50. Pilot+ controller in front compartment
Fig. 51. Pilot+ Controller
Fig. 52. Keep area beneath seat lift free of cabling.
24
Pilot + output stage