Permobil Chairman 2k Service Manual page 17

9. Unscrew and remove the screw holding the
lower shock absorber fastener (31:1) and bend
the shock absorber upwards.
10. Loosen the three screws holding the motor
approx. 1 revolution, see fig. 31:2.
11. Detach the spring strut by unscrewing and
removing the screw on the back edge of the
spring strut, see fig. 31:3.
12. Detach the drive motor by unscrewing and
removing the three screws holding the motor,
see fig. 31:2.
Fitting
Fitting is performed in reverse order.
NB! Check that the drive motor: transition ratio is
correct. The ratio is shown on the transmission
identification decal, see fig. 32.
3
Fig. 31. Detachment of drive motor
Fig. 32. Transmission identification decal.
17
Drive motor
1
2