Table of Contents
Advertisement
Drive motor
Drive motor
Removal
1. Run the seat up to its highest position.
See page 7 for instructions to raise seat
manually.
2. Switch off the main power switch on the control
panel.
3. Put the circuit breaker in the "OFF" position,
see fig. 28.
4. Detach the seat lift and chassis covers as well
as the front fender on the side where the drive
motor will be replaced, see page 8.
5. Jack up the relevant side of the wheelchair.
6. Detach the drive wheel, see page 10.
7. Loosen the electrical connections to the motor
and the magnetic wheel lock, see fig. 29.
8. Draw the cable casing forwards and in front of
the cable through the slot in the cable holder,
unfasten the wheel lock release cable from the
magnetic wheel lock, see fig. 30.
Fig. 28. Circuit breaker 63A (Off/On)
Fig. 29. Electrical connections for drive
motor and magnetic wheel lock.
Fig. 30. Unfasten the wheel lock release cable.
16
Hide quick links:
Advertisement
Table of Contents
