Seat Elevator; Seat Lift - Permobil Chairman 2k Service Manual

Seat lift

Seat lift
Removal
1. Raise the seat using the accompanying seat
lift crank, see page 7. Raise the seat until it will
not go any higher while you crank, i.e. the seat
lift is "not engaging".
2. Switch off the main power switch on the
control panel.
3. Set the circuit breaker to the "OFF" position,
see page 30, fig. 66.
4. Detach the seat lift and chassis covers,
see page 8.
5. Clip off the wiring bundle tie mounted on the
cabling between the seat and the chassis.
6. Remove the seat lift motor's cable connection,
pay attention to the placement of the cables
for purposes of later remounting, see page 21.
7. Lift out the seat, place it on its side next to the
chassis, see fig. 33.
NB! The seat is heavy, hence there should be two
people to do this. Be careful with the cabling.
8. Unscrew and remove the two screws on the
seat lift's upper fastener, see fig. 34.
9. Remove the two screws on the seat lift's lower
fastener, see fig. 35.
10. Detach the seat lift by drawing it straight up.
11. Clip off the wiring bundle tie holding together the
seat lift cabling, follow the cabling to its end, and
loosen the contact at the SLS Drive, as well as
the conductor joint located beside the SLS Drive.
Fig. 33. Lift out the seat.
Fig. 34. Unscrew and remove the screws
from the upper fastener.
Fig. 35. Loosen the screws
on the lower fastener.
18