Fargo DTC1000Me Service Manual page 44

Step Procedure
6 Replace with the new roller.
Install the Mag Roller from the back to hold the roller in place.
Make sure roller sits in front tab (hidden) in front sideplate.
Make sure tabs line up and snap into place. Wiggle in place.
NOTE: Do not hold the roller by the rubber but only from the plastic shaft. The rubber can move out
of position on the shaft and cause a print quality issue.
7 Install the Ribbon Deflector Plate.
8 Re-install Stepper Motor assembly
9 Procedure is complete.
November 2013
.
DTC1000Me-1250e-4250e-4500e Card Printer Service Manual PLT-01543 rev 1.0
44