Charger Board (Part-N3); Battery (Part-N4); Keypad Cable (Part-O1); Keypad (Part-O2) - Advantech RSB-4210 Evaluation Kit User Manual

2.1.19

Charger Board (Part-N3)

The charger board provides the 12V power to charge the battery when
plug-in the 19V adapter. And RSB-4210 can read the battery status
through this charger board.
Note: It has to use 19V adapter for charger board, but 12V adapter cannot.
2.1.20

Battery (Part-N4)

The battery can provide the power for RSB-4210 without any adapter.
2.1.21

Keypad Cable (Part-O1)

The keypad cable connects RSB-4210 (KEYPAD1) and the keypad.
2.1.22

Keypad (Part-O2)

8*8 arrays of 64 normally open single-pole switches. (6*6 region of keypad
are available when using RSB-4210.)
2.1.23

Cable for Suspend/Reset Button (Part-P)

This cable is with a button. It uses to extend the Suspend/Reset function
with a button.
2.1.24

COM Port Cable (D-SUB 9P to Housing) (Part-Q)

The cable uses to extend COM port 9pin header from RSB-4210 to D-SUB
9P serial port connector.
2.1.25

RS-232 Loopback (Part-R)

The terminal connector 9P female uses for testing RS-232 loopback function.
2.1.26

Terminal Block for CAN/RS-485 (Part-S)

The terminal block can extend with extra 2 cables to connect RSB-4210
CAB/RS-485 function with the others CAN/RS-485 devices.
RSB-4210 Evaluation Kit User Manual 12