Driver Installations - Icom id- rp2000v Instruction Manual

D Microsoft ®
Windows Vista™
Manual un-installation from each unit and connector
is needed when using Microsoft
In this section, describes the un-installation instruc-
tion with the ID-RP2000V [SERVICE T] for example.
®
Windows Vista™.
Click
Click
Click
Click
q Start up Windows.
w Connect the PC and the ID-RP2000V [SERVICE T]
connector through a USB cable.
e Open the "Device Manager" screen.
■ COM port confirmation (p 24)
"
• See
"Device Manager" with Microsoft
r Click "
" of Ports (COM&LPT).
Right click the "ICOM ID-RP2000V SERVICE T
(COM✱)" , then select "Uninstall".
t Click to add the check mark, "✔," into "Delete the
driver software for this device." then click [OK].
y Right click the "ICOM ID-RP2000V SERVICE✱" ,
then select "Uninstall".
u Click to add the check mark, "✔," into "Delete the
driver software for this device." then click [OK].
NOTE: Un-install the USB drivers for ID-RP2000V
[SERVICE R] with the same manner.
26
DRIVER INSTALLATION
" to open the
®
Windows Vista™
4
.