Operation Procedure - Horizon Fitness Horizon PC-45 Instruction Manual

3. Operation Procedure

3-1 Operation Procedure
This section shows how to operate PC-45.
WARNING
- Do not put your hands under knife
while power is on.
- Assign only "ONE" operator to oper-
ate PC-45.
- It is dangerous to remain knife on
half position for fear of cutting hands
or fingers. Make sure to return knife to
home position.
CAUTION
- Cut only paper sheets. Otherwise PC-
45 may be broken.
1.
Turn on power with key switch.
2.
Press the Standby button.
- Check that the Standby button lights.
3.
Turn clamper hand wheel counterclock-
wise to raise clamper.
4.
Loosen the back gauge locking screw.
5.
Adjust back gauge according to cutting
with back gauge handle.
NOTE
- Move back gauge from rear side to front
side. Otherwise, it errs in cutting width.
- Cutting line helps to see cutting position.
Cutting line is the beam that is reflected on
sheets.
6.
Tighten the back gauge locking screw.
Clamper Hand Wheel
Clamper
Scale
Back Gauge Handle
14
Standby Button
Key Switch
Back Gauge
Locking Screw
Back Gauge Dial