Horizon Fitness Horizon PC-45 Instruction Manual page 35

6-2 Knife Replacement
7.
Turn on power with key switch.
8.
Press cut buttons A and B to lower knife
until all four knife securing bolts appear.
NOTE
- Do not lower knife too low. Otherwise knife
cannot be removed.
9.
Turn off power with key switch.
10.
Press the Standby button.
- Check that the Standby button lights.
11.
Open front cover.
12.
Remove the center two of four knife secur-
ing bolts with box wrench.
13.
Fasten knife holders enough.
WARNING
- Fastening knife holder insufficiently
may cause knife to fall and severe
injury to operators as a result. Do
fasten knife holder completely as
shown in the drawing below.
Knife
Knife Holder
29
Knife Securing Bolts
Cut Button A
Key Switch
Knife Securing Bolts
Knife Holder
6. Maintenance
Cut Button A
Standby Button