Main Parts Descriptions - Horizon Fitness Horizon PC-45 Instruction Manual

1. Before You Begin
1-3 Machine Descriptions

1-3-2 Main Parts Descriptions

Counter
Back Gauge
This gauge is used to position cutting
width.
Side Gauge and Back Gauge Scale
This gauge is used to square-up both sides
of sheets.
Clamper Hand Wheel
This wheel is used to raise/lower clamper.
Knife
Clamper
This clamper presses sheets not to move
during cutting.
Back Gauge Locking Screw
This screw locks the back gauge not to
move after the back gauge is fit to
position cutting width.
Back Gauge Dial
This dial is used to measure cutting width.
Back Gauge Handle
This handle is used to move back gauge
either forward or backward.
Back gauge is moved by 5 mm when this
handle makes one turn.
Scales are used to adjust cutting position.
Scales are marked in 0.5 mm intervals.
When this handle is pulled, it is free to
move.
4