Serverboard Features; Processors; Memory; Serial Ata - Supero SUPERSERVER8027R-TRF+/7RFT+ User Manual

Table of Contents

Advertisement

SUPERSERVER 8027R-TRF+/7RFT+ USER'S MANUAL
1-2

Serverboard Features

At the heart of the SuperServer 8027R-TRF+/7RFT+ lies the X9QRi-F+/X9QR7-TF+,
a dual processor serverboard based on the Intel
features of the X9QRi-F+/X9QR7-TF+. (See Figure 1-1 for a block diagram of the
chipset).

Processors

The X9QRi-F+/X9QR7-TF+ supports up to four E5-4600 series processors in
Socket R-LGA 2011 type sockets. Each processor supports two full-width Intel
QuickPath Interconnect (QPI) links (with support of up to 8.0 GT/s per QPI link and
with Data Transfer Rate of up to 8.0 GT/s per direction) Please refer to our web site
for a complete listing of supported processors (www.supermicro.com).

Memory

The X9QRi-F+/X9QR7-TF+ has thirty-two (32) single/dual/tri/quad channel 240-
pin DIMM sockets that can support up to 1024 GB of Registered (RDIMM),
Load Reduced (LRDIMM) ECC or Unbuffered (UDIMM) ECC/Non-ECC
DDR3 1600/1333/1066/800 MHz speed SDRAM in a two-channel memory bus.
Memory sizes of 1GB, 2GB, 4GB, 8GB,16GB and 32GB size @ 1.35V/1.5V voltage
are supported. Please refer to Chapter 5 for installing memory.
N o t e :
L R D I M M
DDR3 1333/1066/800 MHz speeds.

Serial ATA

An on-chip (Intel C602) SATA controller is integrated into the X9QRi-F+/X9QR7-TF+
serverboard to provide a six-port SATA subsystem (two SATA 3.0 and four SATA
2.0 ports), which is RAID 0, 1, 5 and 10 (Windows/LINUX) supported. The SATA
drives are hot-swappable units.
Note: You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.

SAS

The 8027R-7RFT+ server only has an integrated LSI 2208 SAS controller on its
the X9QR7-TF+ serverboard. It supports Hardware RAID of RAID 0, 1, 5, 6 and 10.
The SAS drives are hot-swappable units.
Note: The operating system you use must have RAID support to enable the
hotswap capability and RAID function of the SAS drives.
( R e d u c e d
L o a d )
1-2
®
C602 chipset. Below are the main
m e m o r y
s u p p o r t s
o n l y

Advertisement

Table of Contents
loading

This manual is also suitable for:

Superserver 8027r-trf+Superserver 8027r-7rft+

Table of Contents