Table of Contents
Advertisement
SUPERSERVER 8027R-TRF+/7RFT+ USER'S MANUAL
Installing a Hard Drive and Hard Drive Carrier into the Chassis (Figure 6-11)
1. Insert the hard drive and hard drive carrier into the hard drive carrier slot in
the chassis.
2. Fold the HDD carrier's handle inward until it clicks into the locked position.
Figure 6-11: Installing the Hard Drive and Carrier into the Chassis
1
2
Caution: All of the drive carriers must remain in the drive bays to maintain proper
cooling airfl ow.
Caution: Enterprise level hard disk drives are recommended for use in
Supermicro chassis and servers. For information on recommended HDDs,
visit the Supermicro Web site at http://www.supermicro.com/products/nfo/fi les/
storage/SAS-CompList.pdf
6-8
Power Supply
The SC828 chassis has two 1400 Watt power supply. This power supply is auto-
switching capable, which enables it to automatically sense and operate at a 100V to
240V input voltage. In the unlikely event that a power supply unit fails, the system
will shut down and you will need to change the power supply unit. New units can
be ordered directly from Supermicro (see contact information in the Preface).
Removing the Power Supply
Power Supply Removal
1. Unplug all power leading to the chassis.
2. On the front of the chassis, press the release button on the front face of the
power supply (Figure 6-12).
3. Lift the handle upwards (Figure 6-12).
1
1
6-10
Advertisement
Table of Contents
