Appendix B System Specifi Cations - Supero SUPERSERVER8027R-TRF+/7RFT+ User Manual

Table of Contents

Advertisement

Appendix B: System Specifi cations
Appendix B
System Specifi cations
Processors
Quad Intel E5-4600 series series (Socket R-LGA 2011 type) processors
Note: You must install at least two processors for full functions to be supported.
Note: Please refer to our web site for a complete listing of supported processors.
Chipset
One Intel C602 chipset
BIOS
16 MB SPI AMI BIOS® SM Flash BIOS
Memory Capacity
The X9QRi-F+/X9QR7-TF+ serverboard supports thirty-two (32) single/dual/
tri/quad channel 240-pin DIMM sockets that can support up to 1024 GB
of Registered (RDIMM), Load Reduced (LRDIMM) ECC or Unbuffered
(UDIMM) ECC/Non-ECC DDR3 1600/1333/1066/800 MHz speed
SDRAM in a two-channel memory bus with memory sizes of
1GB, 2GB, 4GB, 8GB,16GB and 32GB size @ 1.35V/1.5V voltages.
Note: LRDIMM (Reduced Load) memory supports only DDR3 1333/1066/800 MHz speeds.
See the memory section in Chapter 5 for details.
SAS/SATA Controller
Intel C602 on-chip controller for six-port Serial ATA RAID 0, 1, 5 and 10
WINDOWS/LINUX supported) or eight-port SAS (RAID 0, 1, 5, 6 and 10)
(8027R-7RFT+ serverboard only)
Drive Bays
The SuperServer 8027R-TRF+/7RFT+ has six (6) hot-swap drive bays to house
up to six SATA or SAS drives.
Expansion Slots
Four PCI low-profi le expansion card slots are available in the rear of the chassis
for two (2) PCI Express 3.0 x16 slots (Slot1/Slot3) and two (2) PCI Express 3.0 x8
in x 16 slots (Slot2/Slot4)
B-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Superserver 8027r-trf+Superserver 8027r-7rft+

Table of Contents