Table of Contents
Advertisement
6. Configure the device. The following network and port settings for the device can be
configured in a Telnet session:
Device settings (for the interface converter device):
• IP address
• Net mask
• Gateway
• NetBios name (Device Name)
• Workgroup
Port settings (for each serial port individually):
• TCP port number
• Port mode (see Advanced Settings on page 8 for a description of
various port modes)
• Baud rate
• Data bits
• Parity
• Stop bits
• Flow control
After changing settings, the interface converter will be reset.
Instruction Manual
6
the
Advertisement
Table of Contents
