1 port rs232 serial over ip device server (18 pages)
Summary of Contents for StarTech.com USB4000IP
Page 1
USB Ethernet Network Device Server - 4 Ports USB4000IP...
Page 2
StarTech.com, or an endorsement of the product(s) to which this manual applies by the third-party company in question. Regardless of any direct acknowl- edgement elsewhere in the body of this document, StarTech.com hereby acknowledges that all...
Instruction Manual Instruction Manual Table of Contents Introduction ................... 1 Features ..................1 Package Contents ...............1 Installation Instructions ..............2 Installing the USB Server Hardware ..........2 Installing the Server Utility Software ..........3 Using Your First USB Device ............5 Technical Support ................. 7 Warranty Information ..............
Network Device Server - 4 Ports. This convenient unit allows you to share USB devices over a network/IP so they can be accessed on multiple com- puters. The USB4000IP also enables you to connect printers, scanners, card readers, external drives and more. Reach your USB devices from anywhere on your LAN.
Instruction Manual Installation Instructions Installing the USB Server Hardware Note: Do not connect your USB device(s) to the USB Server until you have finished installing the USB Server software and hardware! Step 1 - Connect the USB Server to Your Network First connect one end of an ethernet cable to the USB Server’s Ethernet port, and the other to your network.
Instruction Manual Installing the Server Utility Software The following instructions outline the installation of th eserver Utility software for all versions of Windows operating systems. Although screen shots of the Server Utility software may not match your operating sy- ustem, please note that the button, menu, and tab names are all identical on both platforms.
Page 7
Instruction Manual During and/or after the software installation, the Windows New Hardware Wizard may ask you to install software several times. Select ‘Install the software automatically’ and click next until the New Hardware Wizard completes the installation. NOTE: You will not be able to use your USB Server until you complete the New Hardware Wizard process.
Instruction Manual Using Your First USB Device Step 1 - Connecting a USB Device to the USB Server Once a USB device is connected to the USB Server, open the Phoenix- Bridge2 Server Utility. You will see the names of USB devices listed in this application.
Page 9
Instruction Manual Step 2 - Connecting a USB Device To connect a USB device to your computer via the USB Server, select the USB device then click Connect under the device list as shown below: Step 3 - Disconnecting USB Devices When finished using a USB device, you must disconnect it from your computer before it is available to everyone else on the network.
Limitation of Liability In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their officers, directors, employees or agents) for any damages (whether direct or indirect, special, punitive, incidental, consequential, or...
Page 11
StarTech.com has been making “hard-to-find easy” since 1985, providing high quality solutions to a diverse IT and A/V customer base that spans many channels, including government, education and industrial facilities to name just a few. We offer an unmatched selection of computer parts, cables, A/V products, KVM and Serv-...