StarTech.com. Where they occur these references are for illustrative purposes only and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which this manual applies by the third-party company in question. Regardless of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby...
Table of Contents Introduction ....................1 Packaging Contents ..........................1 Installation ....................2 Hardware Installation ..........................2 Installing the Server Utility Software ....................2 Using Your First USB Device ..............5 Technical Support ..................7 Warranty Information ................7 Instruction Manual...
Server - 4 Ports. This convenient unit allows you to share USB devices over a network/ IP so they can be accessed on multiple computers. The USB4000IP also enables you to connect printers, scanners, card readers, external drives and more. Reach your USB devices from anywhere on your LAN.
Installation Hardware Installation Note: Do not connect your USB device(s) to the USB Server until you have finished installing the USB Server software and hardware! Step 1 - Connect the USB Server to Your Network First connect one end of an ethernet cable to the USB Server’s Ethernet port, and the other to your network.
Page 6
During and/or after the software installation, the Windows New Hardware Wizard may ask you to install software several times. Select ‘Install the software automatically’ and click next until the New Hardware Wizard completes the installation. NOTE: You will not be able to use your USB Server until you complete the New Hardware Wizard process.
Page 7
Step 2 - Running the PhoenixBridge2 Server Utility Application Once the installation is complete, click the PhoenixBridge2 icon on the desktop. This will launch the PhoenixBridge2 Server Utility Application which is used to configure the USB Server. Instruction Manual...
Using Your First USB Device Step 1 - Connecting a USB Device to the USB Server Once a USB device is connected to the USB Server, open the PhoenixBridge2 Server Utility. You will see the names of USB devices listed in this application. Instruction Manual...
Page 9
Step 2 - Connecting a USB Device To connect a USB device to your computer via the USB Server, select the USB device then click Connect under the device list as shown below: Step 3 - Disconnecting USB Devices When finished using a USB device, you must disconnect it from your computer before it is available to everyone else on the network.
Limitation of Liability In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their officers, directors, employees or agents) for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of profits, loss of business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the product.
Page 11
StarTech.com is an ISO 9001 Registered manufacturer of connectivity and technology parts. StarTech.com was founded in 1985 and has operations in the United States, Canada, the United Kingdom and Taiwan servicing a worldwide market.
Need help?
Do you have a question about the USB4000IP and is the answer not in the manual?
Questions and answers