Mechanical disassemblies
9
-1
Ducts, R/C 2 Board, Filter Unit, NET Board and Panel removal.
1. Remove 2 screws-A and remove the Duct D.
2. Remove 2 screws-B and remove the Duct C.
3. Remove screw-C and remove the R/C 2 Board.
4. Pull out Air Filter Unit.
5. Pulling up center frame of Filter top, separate Filter top and Sheet from Filter base.
6. Remove 3 screws-D and remove the Panel.
7. Remove 2 screws-E and remove the NET Board.
(See Fig.9-1, 9-1a)
CAUTION
Do not operate a projector with air filter removed. Dust may accumulate on LCD panel and
Mirror degrading picture quality.
Do not put small parts into air Intake Vents. It may result in malfunction of a projector.
The filter be careful and handle. The effect of the filter runs out in case of a leak and it being
broken off.
Duct D
E
E
Lens NET Board
D
D
A
A
B
B
Duct C
C
Panel
D
- 36 -
R/C 2 Board
Fig.9-1a
Air Filter Unit
Filter Base
Fig. 9-1
Filter Top
Sheet