Table of Contents
Advertisement
5
-7 PFC Unit 3-4 and Power Unit removal.
PFC Unit 3-4 removal.
1. Remove 4 screws-A and remove the PFC 3-4 Unit.
2. Remove 4 screws-B and remove the Fan (FN914).
3. Remove 3 screws-C and remove the Holder FN.
4. Remove 4 screws-D and remove the PFC 3-4 Board.
5. Remove 2 screws-E and remove the AC4 net Board.
(See Fig.5-7, 5-7a)
Note;
Mark the Fans as they are removed from the holder so that they may be reassembled in the same location from
which they were removed. Be careful of the attached direction of Fan.
See arrow mark in a figure.
PWB units may be reassembled in the same location and direction from which they were removed. Be careful of
the attached direction of PWB units.
E
E
D
D
D
D
C
C
Fig.5-7a
A
A
A
C
B
B
B
B
- 29 -
Mechanical disassemblies
A
Fig.5-7
Advertisement
Table of Contents
