Table of Contents
Advertisement
Lamp replacement
This projector uses a high-pressure lamp which must be handled carefully and properly. Improper handling
may result in accidents, injury, or create a fire hazard.
●
Lamp lifetime may differ from lamp to lamp and according to the environment of use. There is no
guarantee of the same lifetime for each lamp. Some lamps may fail or terminate their lifetime in a shorter
period of time than other similar lamps.
●
If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE INDICATOR lights
up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down.
( Follow carefully the instructions in the LAMP REPLACEMENT section of owner's manual. ) Continuous
use of the lamp with the LAMP REPLACE INDICATOR lighted may increase the risk of lamp explosion.
●
A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its
lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in which
the projector and lamp are being used.
IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.
If a lamp explodes, disconnect the projector's AC plug from the AC outlet immediately. Contact an
authorized service station for a checkup of the unit and replacement of the lamp. Additionally, check
carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out
from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one
should check the inside of the projector except those who are authorized trained technicians and who are
familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those who
are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken glass.
●
How to check Lamp Used Time
You can check the lamp used time and projector used time following to below
procedure.
1
Enter special menu mode.
Press and hold POWER ON-OFF button on the side control of the projector
or the remote control unit for more than 20 seconds.
Press point Up(
) and DOWN (
press "SELECT" button.
2
The projector used time and lamp used time will be displayed on the screen.
3
Press Power button "ON-OFF" once and close the special menu mode.
The LAMP REPLACE indicator will light yellow when the total lamp used time
reaches 2,000 hours - (✽).
required.
(✽) The specification is subject to change without notice.
LAMP HANDLING PRECAUTIONS
)buttons to select "Counter" and than
This is to indicate that lamp replacement is
- 12 -
Special
Counter
Fan control
RS232C
Counter
Projector
123H
Lamp 1
123H
Lamp 2
123H
123H
Lamp 3
Lamp 4
123H
Advertisement
Table of Contents
