Vga Display Software Configuration - Advantech PCM-4825 User Manual

486-based single board computer with svga/lcd and audio interface

Hide thumbs Also See for PCM-4825:

Table of Contents

3.3 VGA display software configuration

The PCM-4825/4825L on-board VGA/LCD interface supports a

wide range of popular LCD, EL, gas plasma flat panel displays and

traditional analog CRT monitors. The interface can drive CRT

displays with resolutions up to 1280 x 1024 in 16 colors. It is also

capable of driving color panel displays with resolutions of 1024 x

768. The LCD type is configured completely via the software

utility, so you do not have to set any jumpers. Configure the LCD

type as follows:

1. Apply power to the PCM-4825/4825L with a color TFT display

attached. This is the default setting for the PCM-4825/4825L.

Ensure that the AWDFLASH.EXE and *.BIN files are located

in the working drive.

NOTE:

2. At the prompt, type AWDFLASH.EXE and press <Enter>. The

VGA configuration program will then display the following:

PCM-4825/4825L User's Manual

Ensure that you do not run AWDFLASH.EXE

while your system is operating in EMM386 mode.

Figure 3-2: BIOS VGA setup screen

Table of Contents

Pcm-4825l