Advantech PCM-4825 User Manual page 57

Type:
A: <ENTER> to make this the default drive.
SETUP A: C: <ENTER>
where A: is the floppy disk drive and C: is the hard drive
When the setup program is completed, you will need to perform a
shutdown and then restart the system in order for changes to take
effect.
A log of the information output during the install can be found in
<root>:\OS2\INSTALL\DISPLAY.LOG
4. After restarting the system, perform the following steps:
1. Open the OS/2 System folder.
2. Open the System Setup folder.
3. Open the Display Driver Install Object
This step will execute the Display Driver Installation (DSPINSTL)
utility program to finish installation of the new drivers.
4. When the Display Driver Install window appears, select
Primary Display and then select OK.
5. When The Primary Display Driver List window appears,
select "Chips and Technologies 65550/554" from the list
of adapter types, then select OK to install the video driver.
6. When the installation is complete, you will need to
shutdown and then restart the system for the changes to
take effect. Make sure to remove the install diskette
before restarting the system.
When the system has restarted, the display driver will be initialized
for 640x480x256 color, 60 Hz refresh. To switch to a different
video resolution, color depth or refresh rate, follow the steps
below.
5.8.3 Selecting monitor type
50 PCM-4825/4845L User's Manual