Vga Display Software Configuration - Advantech PCM-5825 User Manual

3.3

VGA display software configuration

The PCM-5825 on-board VGA/LCD interface supports an 18-bit TFT
LCD, flat panel displays and traditional analog CRT monitors. The
interface can drive CRT displays with resolutions up to 1024 x 768 in 16
bpp. It is also capable of driving color panel displays with resolutions
of 1024 x 768 in 18 bpp. The LCD type is configured completely via the
software utility, so you do not have to set any jumpers. Configure the
LCD type as follows:
1. Apply power to the PCM-5825 with a color TFT display attached.
This is the default setting for the PCM-5825. Make sure that the
AWDFLASH.EXE and *.BIN files are located in the working drive.
Note:
2. At the prompt, type AWDFLASH.EXE and press <Enter>. The
VGA configuration program will then display the following:
3. At the prompt, type in the BIN file which supports your display.
Make sure that you do not run AWDFLASH.EXE
while your system is operating in EMM386 mode.
Figure 3-2: BIOS VGA setup screen
Chapter 3 Software Configuration 2 9