Step 3; Os/2 Drivers Setup Procedure; Preliminary Steps; Installing From Diskette - Advantech PCM-4825 User Manual

486-based single board computer with svga/lcd and audio interface

Hide thumbs Also See for PCM-4825:

Table of Contents

5.7.3 Step 3

1.Upon restarting your computer, select the desired display settings

from the Display property dialog box.

2.Click on Test to test the newly selected graphics mode. A color

test screen should appear, followed by the Testing Mode window.

3.Click on Yes to continue. Click on Apply to switch to the new

graphics mode.

4.Since graphics modes are changed dynamically with NT 4.0, you

need not shutdown and restart to give effect to the new screen

settings.

The following steps must be performed before you install the

65550/554 display driver:

1. OS/2 DOS support must be installed.

2. If you previously installed SVGA support, you must reset the

system to VGA mode. VGA is the default video mode enabled

when OS/2 is installed.

To restore VGA mode, use Selective Install and select VGA for

Primary Display. For more information on this procedure, see the

section on Changing Display Adapter Support in the OS/2 User's

Guide.

To install this driver, do the following steps:

1. Open an OS/2 full screen or window session.

2. Place the 65550 Display Driver Diskette in drive A.

3. At the OS/2 command prompt, type the following commands to

copy the files to the OS/2 drive:

Chapter 5 SVGA Setup

Table of Contents

Pcm-4825l