Ann-Bus; Ann-Bus Enabled; Bus Modules - Honeywell MS-5UD Series Manual

Programming

3.5.5.1 ANN-BUS

Pressing 1 while viewing the Option Modules screen will cause the control panel to display the
following screens.
A variety of ANN-BUS option modules can be installed in the FACP. These devices
communicate with the FACP over the ANN-BUS terminals on the control panel.

3.5.5.1.1 ANN-BUS Enabled

The ANN-BUS must be enabled if any modules are installed on the ANN-BUS terminals. To
enable the ANN-BUS, press 1 while viewing ANN-BUS screen #1 so that the display reads
ANN-BUS Enabled Yes. Each press of the 1 key will cause the display to toggle between ANN-
BUS Enabled Yes and ANN-BUS Enabled No.

3.5.5.1.2 BUS Modules

If an ANN-BUS module is installed, press 2 while viewing ANN-BUS screen #1 to select
ANN-BUS addresses for the module(s). The following screen will be displayed.
Pressing the down arrow key will allow the programmer to view additional screens displaying
Addresses 1 - 8. Pressing the number corresponding to the desired address will display a screen
with technical information about the selected module.
80
ANN-BUS
1=BUS ENABLED
2=BUS MODULES
3=AUTO CONFIGURE
ANN-BUS Screen #1
ANN-BUS
1=ANN-S/PG OPTIONS
2=ANN-80 OPTIONS
3=ANN-RLY OPTIONS
ANN-BUS Screen #2
ANN-BUS
1=ANN-AUDIO OPTIONS
ANN-BUS Screen #3
ANN-BUS MODULES
1=ADDR. 1
2=ADDR. 2
3=ADDR. 3
On Board DACT Screen #1
NO
NONE
NONE
NONE
MS-5UD/MS-10UD Series PN 52626:B 8/01/2008