Auto Silence; Silence Inhibited; Relays - Honeywell MS-5UD Series Manual

PROGRAM NAC #
1=SILENCEABLE YES

2=AUTO SILENCE

NO
3=SIL INHIBITED NO
NAC Screen #2

3.5.3 Relays

PROGRAMMING
Pressing 3 while viewing Programming Screen #1 will allow the programmer to configure the three
1=INPUT ZONES
main circuit board Form-C relays. The following screen will be displayed:
2=NACS
3=RELAYS
Programming Screen #1
MS-5UD/MS-10UD Series PN 52626:B 8/01/2008
3.5.2.4 Auto Silence
The Auto Silence feature, when enabled, automatically silences all main circuit board
silenceable notification appliances after a programmed length of time. To enable this feature
and program the time delay before Auto Silence activation, press 2 while viewing NAC Screen
#2. The following screens will be displayed:
AUTO SILENCE
1=NO
2=5 MINUTES
3=10 MINUTES
Auto Silence Screen #1
1=15 MINUTES
2=20 MINUTES
3=25 MINUTES
Auto Silence Screen #2
AUTO SILENCE
1=30 MINUTES
To disable the Auto Silence feature, press 1 for No while viewing Auto Silence Screen #1. To
enable the Auto Silence feature, press the number corresponding to the time delay which will
elapse before Auto Silence activates. This information will be stored in memory and the
display will return to NAC Screen #1.

3.5.2.5 Silence Inhibited

The Silence Inhibit feature, when enabled, prevents the silencing of the selected main circuit
board NAC for a period of one minute. Resetting the FACP will also be prevented for one
minute while the NAC programmed for silence inhibit is activated. Pressing 3 while viewing
NAC Screen #2 will cause the display to change from the factory default of Silence Inhibit No
to Silence Inhibit Yes. Each press of the 3 key will cause the display to toggle between the two
options.
1=RELAY 1
2=RELAY 2
3=RELAY 3
AUTO SILENCE
Auto Silence Screen #3
RELAYS
ALARM
TROUBLE
SUPERV
Relays Selection Screen
Programming
71