Time-Date; Time - Honeywell MS-5UD Series Manual

SYSTEM SETUP
1=TIMERS
2=BANNER

3=TIME-DATE

System Setup Screen #1
MS-5UD/MS-10UD Series PN 52626:B 8/01/2008
3.5.4.3 Time-Date
The control panel time and date can be changed by pressing 3 while viewing the System Setup
Screen #1. The following screen will be displayed:

1=TIME

2=DATE
3=CLOCK FORMAT
1=DAYLIGHT SAVINGS
3.5.4.3.1 Time
To change the time, press 1 while viewing the Time-Date Screen. The following screen will be
displayed:
ENTER TIME AS 12HRS
1=AM
A flashing cursor is located toward the top left of the display. Below the cursor is the current
time. To change the time, enter the two-digit hours followed by the two-digit minutes. The
cursor will move one position to the right each time a digit is entered. After the last minutes
digit is entered, the cursor will again move one position to the right. At this point enter 1 for
AM or 2 for PM. The display will then return to the Time-Date Screen which will show the
new time entry. If an error is made while entering a digit, press the CLR key to delete the entire
entry and beginning again.
TIME AND DATE
10:00 AM
07072007
Time-Date Screen #1
TIME AND DATE
Time-Date Screen #2
:
10:00 AM
Time Screen
Programming
12HR
2=PM
77