Zone Type - Honeywell MS-5UD Series Manual

Programming
INPUT ZONE
1=ENABLED
2=TYPE
3=VERIFICATION
Edit Input Zone Screen #2
60
The following examples show the editing of Input Zone 1:
1=ENABLED
2=TYPE
3=VERIFICATION
1=PAS/PRE-SIG DELAY
1=FREEZE SUPV.
2=ACC MSG#
1=NOUN/ADJECTIVE
2=DESCRIPTION
********************
Enable/Disable Zone
To Enable or Disable the zone, press the 1 key while viewing the Edit Input Zone Screen #2.
Each press of the key will toggle the screen between Enabled Yes and Enabled No. If Enabled
No is selected, the zone will be disabled by the control panel, preventing the circuit from
reporting alarms and troubles to the panel. The control panel LCD will display the zone which
has been disabled and FACP will turn on the Trouble LED.
Type
To select the type of zone being programmed, press the 2 key while viewing the Edit Input Zone
Screen #2. This will cause the control panel to display the following Zone Type Screen:
1=PULL STATION
2=WATERFLOW
3=WATERFLOW NS
INPUT ZONE 1
PULL STATION
Edit Input Zone Screen #2
INPUT ZONE 1
NO DELAY
Edit Input Zone Screen #3
INPUT ZONE 1
Edit Input Zone Screen #4
INPUT ZONE 1
Edit Input Zone Screen #5

ZONE TYPE

Zone Type Screen #1
MS-5UD/MS-10UD Series PN 52626:B 8/01/2008
YES
NO
NO
2