Clear Program; Password Change - Honeywell MS-5UD Series Manual

3.5.8 Clear Program

Pressing 2 while viewing Programming Screen #3, will select the Clear Program option. The
control panel will provide a warning to the user by prompting with the following display:
PROGRAMMING
1=WALKTEST
2=CLEAR PROGRAM

3=PASSWORD CHANGE

Programming Screen #3
Pressing 1 will cause the control panel to carry out the selected clear option. Pressing 2 will
prevent programming from being cleared.
3.5.9 Password Change
PROGRAMMING
The factory set passwords, which have been programmed into the control panel, can be changed by
1=WALKTEST
selecting the Password Change option. Pressing 3 while viewing Programming Screen #3 will
2=CLEAR PROGRAM
cause the following screen to be displayed:
3=PASSWORD CHANGE
Programming Screen #3
Press 1 to change the Master Programming Level password, 2 to change the Maintenance Level
password or 3 to change the Remote Download password. Note that the passwords will not be
displayed on annunciators.
The following screen will appear when one of the change options is selected:
A flashing cursor will appear in the center of the display. Enter a new five digit password (such as
10101 for the Master Level). After the fifth digit is entered, the following screen will be displayed:
The new five digit password must be re-entered to accept the change. The display will then return
to the initial Password Change Screen.
MS-5UD/MS-10UD Series PN 52626:B 8/01/2008
WARNING!
SYSTEM CHANGE
PROCEED?
1=YES
PASSWORD CHANGE
1=MASTER
2=MAINTENANCE
3=REMOTE DOWNLOAD
Password Change Screen
ENTER NEW FIVE DIGIT
PASSWORD
Enter Password Screen
VERIFY NEW
PASSWORD
Password Change Screen
Programming
2=NO
103